High Quality Epoxy Polyester Powder Coating Paint

Powder Coating

1.General introduction:

Powder coatings are mixed with a certain proportion of the resin, fillers, curing agents and other additives, then prepared by hot extrusion ,crushed  and sieved.The products are stable at room temperature storage, then baking heat melted and solidified to form a smooth and bright permanent coating to achieve the purpose of decoration and corrosion.

2.Features:

1).The products are non-toxic, solvent-free and non-toxic volatile substances, there are no intoxication, no fire, no "three wastes" emissions and other pollution problems, in full compliance with national environmental laws. 
2).Raw material utilization is high, the highest utilization rate even more than 99%. 
3).After being pre-coated handle, disposable construction, without primer, you can get a sufficient thickness of the coating, easy to automate operation, high production efficiency, reduce costs. 
4).Dense coating adhesion, good impact strength and toughness, high coverage corners, with excellent resistance to chemical corrosion and electrical insulation properties. 
5).Powder coatings storage and transport are safety and convenience.
   
3.Powder physical properties: 
 
   Proportion : 1.2-1.8 (depending on the color and gloss ) .
 
   Particle size distribution: 100% less than 125 microns (more than 85%          
   between 60 to 90).

   Liquidity(180°C):22~35mm.

   Curing conditions:200°C,10 minutes.

4.Average coverage:

8-10m³/kg, the membrane is 60μm
(calculate by 100% utilization rate of powder coating).

5.Packing:

   Carton packaging, lined with double polyethylene bag, net weight 20 kg.
   
6.Storage requirements:

   Store below 30 °C, ventilated, dry, clean room, not near the fire, heat, direct sunlight, open dumps is prohibited.Under this condition, the powder can be stable for 12 months, more than the storage period may be re-examined, such as the results meet the requirements, can still be used.

7.Health and safety:
 
This product is non-toxic. 
In the course of inhalation of dust should be avoided. The operators should wear  appropriate dust mask and glasses.
 
8.Coating performance
 
9.Why choose our products?

1). We have our own factory. The good quality and the competitive is the advantage of our company. 
2). The material we choose is always good and products always come out with high quality. 
3). A trial order or sample orders are welcomed. 
4). Our products are exported to Europe, America, Southeast Asia, and other countries and regions in the world. 
5). We will do our best to service you all the time if you have the further question.


 

Elevator Complete Control System

OTIS Elevator Complete Control System, Thyssen Elevator Complete Control System, KONE Elevator Complete Control System, GiantKONE Elevator Complete Control System, ThyssenKrupp Elevator Complete Control System, Schindler Elevator Complete Control System, XJ Schindler Elevator Complete Control System, Xizi OTIS Elevator Complete Control System, Mitsubishi Elevator Complete Control System, Shanghai Mitsubishi Elevator Complete Control System, Fujitec Elevator Complete Control System, Hitachi Elevator Complete Control System, Toshiba Elevator Complete Control System, Hyundai Elevator Complete Control System, LG Elevator Complete Control System, Sigma Elevator Complete Control System, Express Elevator Complete Control System, GUANGRI Elevator Complete Control System, FUJI Elevator Complete Control System, BLT Elevator Complete Control System, CANNY Elevator Complete Control System, SJEC Elevator Complete Control System, KOYO Elevator Complete Control System, IFE Elevator Complete Control System

Elevator Control System, Elevator Controller Cabinet, Elevator Control Cabinet, Elevator Controller, Elevator Complete Controller, Elevator Complete Control System, Elevator Control Panel

CEP Elevator Products ( China ) Co., Ltd. , https://www.zjelevatordoorsystem.com