The MAXIMATOR Pneumatic Liquid Pump is used in a wide range of applications and can be filled with water, oil filled or filled with chemical media. The MAXIMATOR Pneumatic Liquid Pump has a liquid output pressure of up to 5500 bar and a gas driven pressure range of 1-10 bar (14.5-145 psi). Its working principle is similar to the reciprocating loop amplifier, the bottom of the piston by the two-way pilot valve to control. The MAXIMATOR pump is a piston displacement pump that converts gas pressure to liquid pressure. The use of a large area piston end of the low pressure to produce a small area of ​​the piston side of the high hydraulic pressure. In operation, the MAXIMATOR pump operates quickly and reciprocally, and as the output pressure approaches the set pressure, the pump's reciprocation slows down until it stops. At this point, both ends of the piston air pressure and hydraulic pressure balance, the piston remained stationary, then the lowest energy consumption, fluid pressure no longer increases, the parts stop moving. On the contrary, the electric pump must operate continuously to maintain a certain pressure output, and the bypass element needs to be flooded. As a result, energy loss and heat increase, bypass elements and larger tanks are required. MAXIMATOR pump structure is simple, high efficiency, compared with other hydraulic pumps, it is undoubtedly more for many industrial and research sites to reduce costs and save energy. Decades of continuous development, MAXIMATOR products in the world has been widely used in the petrochemical, oil and gas industry, chemical and machine tool industry, defense, mining, engineering machinery and aerospace and other fields. Applied to Static Pressure Testing MAXIMATOR pumps are a cost-effective option for pressure testing hoses, tubes, valves, fittings and other hydraulic vessels and products. Used to replace manual pump, saving time, effort, high efficiency. Applications Industrial machinery MAXIMATOR pump output high pressure can be used in clamping, holding, forming, cutting, stamping and other machines. For example: used in a long time holding pressure, and the pressure is high, while the short stroke on the press. Using high and low pressure pump combination, can achieve low cost, high pressure, high speed. No central power source MAXIMATOR pump size is small, can be used as a power source installed directly on a single device. No central power source required, reducing piping and energy loss along the way.
