After everything is completed, it is finally possible to check the house. Dream homes seem to be in the hands of people. Actually, your task is still very difficult, because acceptance is not so simple. The developer sends a “check-in notice†to the home buyer or informs the home buyer to pick up the notice at the appointed place. At this time, the home buyer is advised to press the check-in. Because the contract is generally agreed, if the buyer fails to go to the inspection room within the agreed time limit, it is deemed that the purchaser agrees to transfer.
The acceptance of a house is divided into four parts: First, it depends on whether the developer has the contractual conditions of delivery. When the home buyer goes to the inspection and acceptance transfer according to the contract, the relevant certification documents shall be checked item by item according to the delivery conditions agreed in the contract. Second, we must focus on acceptance of housing quality. Check the quality of the house in detail, whether there are cracks or cracks in key areas, check whether the wall surface and the ground are smooth, smooth, etc. Check whether the water, electricity, natural gas, water pipes, etc. are opened and whether they can be used normally; check the layout of the house. And whether the height accords with the contractual agreement; check the house plan in the purchase contract, check whether the structure of the room is consistent with the drawings, and whether the area, span, length and width of the room are reasonable and so on.
Third, we must check if there is a difference between the area of ​​the housing agreed in the contract and the actual area. The general contract stipulates that when a commercial house is delivered, the difference between the actual area of ​​the house and the temporarily measured area shall not exceed ±2% (±3%) of the temporarily measured area, and the house price shall remain unchanged. Whether the supporting facilities agreed in the fourth inspection contract are complete or not, the supporting facilities include the indoor part, including whether the construction of the same period of the community, the handover of the house, the garage, the clubhouse, the greening, the landscape garden, etc. are in compliance with the commitment, and the public parts such as the lobby, corridor, wall, and ground. Whether the ceiling decoration meets the promise, whether the mailbox, elevator, perimeter alarm system is equipped, etc.
Entrance decoration restaurant decoration house room interior decoration
Power frequency transformer isolation, pure sine wave voltage output, high stability and excellent performance, low failure rate, long working life, simple maintenance Control circuit adopt high-performance DSP control chip Three-stage charging management design greatly increase battery`s working life Easy installation,users can get a Solar Power System by connection with PV panels and battery Strong ability against load, meet 100% need of household load Self-protections against under-voltage, over-voltage, over-heat, short circuit, over load, etc. Visual display of various data on LED and Smart meter Can be used in high altitude, high cold area.
300~5000w on-grid Solar Power System
On Grid Solar Power System,On Grid Solar Home System,Solar Generator,On Grid Solar System
Shenzhen Asadal New Energy Tech Co., Ltd. , http://www.asadal-solar.com