As people's lives are getting better and better, everyone's demands for quality of life are getting higher and higher. For the decoration, the previous tiles are always too monolithic. Many people nowadays choose mosaic facades and mosaic facades. A wide variety of styles can choose what you like, then how to construct a mosaic wall ? Let's let Xiaobian explain how to build a mosaic wall !
First, how to build a mosaic wall
1. Processing base
Before the construction, we must treat the outer wall of the cement to smooth the surface of the surface. However, the surface of the outer wall cannot be skipped smooth because it is not conducive to the tile, so we must first cut the hair and then throw the cement off. Fine mortar, made of water-laminated, cured after final coagulation, down to the hardness of their hands until it does not move. If it is the other wall, be sure to clean the wall, and then repair the wall or the windowsill and other loose parts, and then wet the wall with water before construction.
2. Plastering
Plastering the walls is usually carried out twice. The first time the film is thinned, the trowel is used to squeeze the plaster. In the same proportion, the mortar is smoothed with rams, scraped with a short scraper, filled with low-pits, and finally pummeled with a wooden trowel. Then, according to the temperature, the water is cured after final coagulation.
3. Wall bullets
The length and width of the building and the total height of the doors and windows should be advanced. According to the type of mosaic, the width of the slit of the grid should be planned, and several horizontal lines should be popped to process the grid at the same time. Note that there must not be more than one row of non-complete bricks on the same wall, and it should be plastered in concealed areas.
4. Make a mosaic
When we put on the mosaic wall, we must first coat the wet surface with cement mortar and display each set of mosaics on a wooden pad. Fill the gap with one to two dry cement sands, and brush the surface with a brush. Floating sand, scrape a thin layer of cement paste and paste it. Under normal circumstances, paste the mosaic from the bottom up.
5. Aftermath work
After affixing the mosaic, in the early stage of mortar solidification, sprinkle wet protective face paper with tap water, and slowly tear the paper off with both hands. The force orientation when tearing the paper should be parallel to the wall. In addition, you must use the metal plate to bend the gap. Make adjustments to make the distance even, while tapping and flattening on the mosaic board. When the wall is completely dry and twisted, the force orientation of the torn paper should be parallel to the wall. In addition, the metal plate must be used to adjust the bending gap so that the distance between the two is uniform, and at the same time, the board is tapped and pressed on the mosaic board. Wait for the wall to dry completely and wipe clean. Cleaning the wall should be performed after the adhesive layer and the joint mortar have finally set.
The above is all about how to construct a mosaic wall and I hope it will help everyone. If you want to know more relevant knowledge, you can continue to pay attention to the relevant information of this website. Xiao Bian will bring more exciting content for everyone.
Metal Coil Stock,Hindalco Series Aluminium Coil,Series Aluminum Coil Distributors,Series Aluminum Coil Distributors
Jinan Xinhai Aluminum Industry Co., LTD. , https://www.jnxinhai-alu.com