The steps for determining the cable drag chain model are as follows:
1. For the power cable, a margin of not less than 10% must be set, and a margin of not less than 20% must be reserved for the water pipe.
2. Try to avoid putting cables of different material jackets into one drag chain to reduce wear.
3. If you need to place several cables in a chain, separate them with a partition as much as possible. If not, make sure that the internal space does not allow the cables to overlap.
4. Symmetrically placed according to the weight and size of each cable, place heavy and large cables on both sides, and place light and small cables in the middle.
5. Calculate the stroke of the cable, that is, the length of the cable running;
6. Determine the height of the towline support plate according to the diameter of the cable, and then determine the type of the towline and the width of the towline;
7. According to the weight of the cable, the towline has sufficient load-bearing capacity.
Concerned about surprises
Label: How to choose the cable drag chain specification model
Previous: Control cable product description Next: How to use hot oil pump
Scaffolding Planks,Aluminum Planks,Wooden Scaffold Boards,Aluminum Scaffold Plank
Kaiping Youying Metal Products Co., Ltd , https://www.yyscaffold.com