Division of labor before and after maintenance of surface grinder
The surface grinder mainly grinds and grinds the workpiece with a grinding wheel to achieve the required flatness. According to the shape of the table, it can be divided into two types: rectangular table and circular table. The main parameters of the rectangular table surface grinder are the width and length of the table. The main parameter of the round table surface grinder is the work surface diameter. According to the different types of shafts, it can be divided into horizontal shaft and vertical shaft grinding machine. The maintenance work of the surface grinder is divided into different stages, that is, the pre- and post-stage, different work needs to be done at different stages, and only the reasonable division of labor can achieve the efficient maintenance effect of the surface grinder.
Early stage
1. Clean the cooling pump iron filing trough, accessories and water tank and check the coolant, clean and adjust the grinding head and grinding head strip;
2, cleaning oil filter, disk, bed and rail surface, hydraulic pump, pipeline and oil circuit;
3. Check and adjust the pressure of the pressure valve to check whether the hydraulic handles and guide rails are flexible;
4. Check the stroke speed and the oil inlet condition of the guide rail;
5. Fasten the screws of each part;
6. Clean the inside and outside of the surface grinder and fill the lubricating oil of each part.
Late
1. Adjustment of the bearing clearance of the grinding wheel spindle;
2. Grinding the table top and shaving the burrs of each rail surface;
3. Check the oil pump and each pipeline joint, check and adjust the clearance of the screw nut of the feed mechanism;
4. Clean the surface grinder motor and electrical equipment.
Concerned about surprises
Label: Maintenance work for different stages of a surface grinder
Previous: The basic structure and classification of the inverter Next: Analysis of the characteristics of hydroforming technology
XB300 Asbestos Jointing Sheet
XB300 Asbestos Jointing Sheet is pressed with chrysotile asbestos fibers and synthetic or natural rubber as the main materials.
Usage:Suitable for temperature max 300 centigrade in water,vapour,air,gas,ammonia alkali and other mediums transmitted in the joints of facilities and pipelines.
PRESS:3.0MPa(max)
Dimension:
4100×1500mm; 4500 x 1500mm;2000×1500mm;
1500×1500mm;1500×1000mm;1540x1360mm
1270×1300mm; 3810×1300mm
Thickness: 0.5~6.0mm
Technical data:
Lateral Tensile Strength/MPa ≥ 9.0
Aging coefficient ≥ 0.9
Loss on ignition/% ≤ 30.0
Compression ratio/% 7~17
Recovery/% ≥ 40
Creep relaxation rate/% ≤ 50
Density(g/cm3) 1.6~2.0
Xb300 Asbestos Jointing Sheet,Asbestos Jointing Sheet,asbestos rubber jointing sheet,Compressed Jointing Shee
HEBEI HENGDA SEALING MATERIALS CO.,LTD. , https://www.hengdasealing.com