Home>Bearing knowledge>Support frame and other parts information in imported bearings |
Suspension frame and other parts information in imported bearings
Source: Bearing network time: 2018-07-16
/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
1. Collaboration with consistent strength and durability; enables the frame to accept certain loads and impacts; has better elasticity and stiffness.
2. The coefficient of conflict between the roll and the roll.
3. Must have outstanding thermal conductivity.
4. The specific gravity is small and has a coefficient of expansion near the roll.
5. Because the shelf layout is usually more complicated; so the information used in the requirements is outstanding:
6. The stamping molding adheres to the data requirements and has outstanding plasticity and ductility.
7. The car system has an outstanding cutting function for the data requirements.
8. The die casting insists on the data requirements and has an outstanding casting function.
9. Injection molding insists on the data requirements with outstanding injection molding capabilities.
Commonly used materials for imported bearings and rivets, washers, spacers, seals, pillars, and pin-out data are commonly used in imported bearing brackets and rivets, washers, spacers, seals, pillars, pins, etc. Metal materials (such as low carbon steel, stainless steel, etc.), non-ferrous materials (such as brass, bronze and aluminum alloys) and non-metallic materials (such as phenolic cloth bakelite, plastics, etc.) three types of special use of bearings Should be satisfied with the requirements of special operating conditions; such as high temperature resistance, corrosion resistance, self-lubrication (used in vacuum) or non-magnetic.
Stamping is usually made of steel plate; sometimes it is also made of copper plate. This kind of frame is lighter than the metal body. The punching frame holds the open space between the inner and outer rings of the bearing. 3 chicory.
The stamping holder is written into the bearing code as long as it is not used as a specification layout.
The physical support frame is made of metal, phenolic fabric and plastic. These materials are usually indicated in the bearing code.
The metal entity adheres to the work place where the strength of the support frame is high and the temperature is high.
When the demand rib is guided; it can also be used to hold the frame. The high-speed bearing of the rib guide is made of light materials; such as light metal or phenolic resin fabric; to ensure its small inertia.
The polyamide (nylon 66) holder has a very good sliding and self-lubricating function.
The frame made of glass fiber reinforced nylon 66 is used for the operation under the condition that the working temperature does not exceed 120~C.
Recommend to friends comments close window
Bearing related knowledge |
The origin of NTN rolling bearing abnormal phenomenon is the bearing product common sense micro-bearing slewing bearing device needs to grasp six major methods car crankshaft bearing abnormal static and dynamic fault turntable bearing common sense |
This article links to http://
Please indicate China Bearing Network http://
Previous: Bearings on the demand for steel Next: Skill analysis: Ways to improve bearing life
Graphite Part,Other Graphite Parts,High Purity Graphite Part,High Strength Graphite Part
Henan Carbons New Material Technology Co., Ltd. , https://www.hncarbons.com